MCC-B camera control line
Applicable stabilizer: DJI Ronin-s
Camera brands and models supported to control:
A)for canon :EOS 5d Mark IV,5DSR,EOS M50,M50 II,EOS 90D.
B)for nikon:D850,D5,D500
Support for controlling camera functions: take photos, start/stop recording,
"Setting Notes"
1. Due to the camera system, when you need to take pictures, please switch the camera shooting mode to take pictures; When you need to record, switch the camera's shooting mode to record.
Because the USB port of D850,D5, 5D4,5DS R and 1DX3 cameras is a large port, which is composed of two small ports. So just plug it into the socket below and you can use the control
Key points: 1. The length of the line is extended to 35mm/13.8in, and the camera can be stood up for vertical shooting.
2. For better operating experience, the setting items of each brand camera are listed, please check carefully.
3. The port of the DJI Ruying S stabilizer is on the left side of the quick assembly board, and the screen printed with the RSS word socket
4. After plugging in the cable, turn on the power of the stabilizer first, and then turn on the camera to communicate.
5. If there is no response, please turn off the power of the camera and turn it on again
6: If you cannot control the camera, update the firmware version of the DJI S stabilizer to the latest version.
4.0 iš 5, remiantis 4,274 atsiliepimais 
